ELECTRONICS TROUBLESHOOTING

        Back to Table of Contents        Back to Series Circuits       

 

Series Circuit JAVA Troubleshooting Simulation #3

In the circuit below use the "No Fault" condition as a base line to determine which resistor has failed or changed value in each faulty circuit( Fault 1 thru Fault 4.) Then check your result by clicking "Answer" at bottom of page and compare resistor values with those given with schematic.

       Vs = 110.0 Vac   Rs = .4 ohm
      R1 = .05, R2 = 1.0, R3= 10, R4 = .12 ohm

AC Voltmeter Volts

No Fault
Fault 1
Fault 2
Fault 3
Fault 4


 

NOTICE: IN 2015 this site will get a complete makeover.  You will have to go to science-ebooks.com directly in order to see new directory.